Turbo Timer Mode; Telematic Upgrade - Audiovox Prestige Platinum SS9000 Owner's Manual

 Right Or Left Slider Doors in An Equipped Van
 Driver Priority Settings In Vehicles So Equipped
To activate the optional accessory, press the option button on the keychain
transmitter. The optional accessory will immediately engage.
ADDITIONAL REMOTE FUNCTION (CHANNEL 7)
This system has an additional feature that can be connected to a number of differ-
ent optional accessories. Some of the more common uses for this channel are:
 Rear Hatch Release
 Right Or Left Slider Doors in An Equipped Van
 Driver Priority Settings In Vehicles So Equipped
 Second Driver Priority Settings In Vehicles So Equipped
To activate the optional accessory, press the option button on the keychain
transmitter. The optional accessory will immediately engage.
NOTE: If your system utilizes the transmitter shown, the second option button
may be configured to operate additional accessories. Please consult your
installing retailer for more information concerning the options available.

TURBO TIMER MODE

This system provides a means to cool down the vehicles turbo charger, if so
equipped, by allowing the vehicle to continue to run for a prescribed period of time
every time the vehicle's engine is turned off. This feature requires the system to be
set up for turbo timer during installation. Consult with your installation center to be
certain this feature was activated and how long the vehicle will continue to run, 3, 5,
or 10 minutes after the ignition switch is turned off.
To activate the turbo timer:
Anytime the ignition key is in the on position for more than 15 seconds:
1) Place the gear selector in park.
2) Set the parking, (hand), brake.
3) Be certain your foot is off the brake pedal.
4) Press the receiver's program/Push-Button switch 2 times within 5 seconds.
The parking lights will flash two times indicating the mode was successfully en-
tered. If your parking lights flashed four times, this indicates the turbo mode was
on and is now turned off.
With the turbo timer mode selected on, after you've arrived at your destination,
while the engine is still running, set the parking brake, pause 2 seconds, then turn
the ignition switch to the off position. The engine will continue to run the allotted
time according to the selection during installation.
If you do not want the vehicle to continue to run for one cycle, simply step on the
vehicle's brake, or release the parking brake, or activate the transmitter's start
button two times in succession. Any of these will cause the engine to turn off.

TELEMATIC UPGRADE:

This system has the ability to have a telematic upgrade module connected to it.
This is a upgrade that can give you control of certain functions of your vehicle from
a Telephone, or in some cases a computer interface. Please check with your
installation center for most recent Telematic Upgrades. If you had a Telematic
Upgrade installed, the manual supplied with the upgrade unit will provide a opera-
tors manual advising of the features of the system and means available to control
these features of your vehicle.
Page 13
128-8842
13 of 20