Surround Sound; Advanced Remote Control Operation; Manufacturer's Code Settings - Panasonic TX-32F500A Operating Instructions Manual

TX32F500A-2912_E Page 29 Monday, July 18, 2005 5:59 PM

Surround Sound

PICTURE
SOUND
SET UP
TV/AV
TV/TEXT
F.P. INDEX HOLD
i
CH SEARCH STILL
100Hz/
PROGRE
1 2 3
SURROUND
4 5 6
ASPECT
7 8 9

Advanced Remote Control Operation

I Manufacturer's Code Settings
This Remote Control has been designed to work with a variety of VCRs and DVD players. In order for this to occur,
the setting for the VCR or DVD must be programmed into the Remote Control.
1. To set a VCR, slide the Remote Control VCR-DVD switch
To set a DVD, slide the Remote Control VCR-DVD switch
2. Press the Remote Control VCR-DVD Power button
3. Enter the Manufacturer's two-digit code number using the Remote Control Number buttons
codes are shown below.)
4. Press the Stop button
5. Release the Remote Control VCR or DVD Power button
6. Check the operation of the VCR or DVD. If it does not operate correctly, repeat steps 1 to 5 and use an alternate
code (if there is one).
VCR Codes
Manufacturer
Panasonic/National
AIWA
FUJITSU
HITACHI
JVC
MITSUBISHI
DVD Codes
Manufacturer
Panasonic
Notes:
1. If the batteries are removed from the Remote Control, the Manufacturer's codes are lost and must be
reprogrammed.
2. The list of Manufacturer's codes is given as a guideline only. Panasonic cannot guarantee that any other
manufacturer's product will work with this Remote Control.
Surround
SURROUND
This button switches the Dolby Virtual surround on and off.
Please refer to page 20.
Stereo / Mono
Pressing the button changes the mode from Stereo ( ) to
Mono ( ) and back again. Normally the television will detect
whether the broadcast signal is Mono or Stereo and will set
the mode accordingly. If the Stereo signal is weak or if the
receiving conditions are not the best, it is recommended that
the Mono mode be manually selected.
Bilingual *
This system allows two languages to be transmitted for one
broadcast. Switching between the Main ( I ) and Sub ( II )
positions selects the desired languages.
* Note:
• Bilingual sound is currently not available in Australia or
New Zealand.
DVD
and keep it pressed.
VCR
.
Code Manufacturer
10, 11, 12, 13 NEC
15, 16 ORION
20 Philips
25, 26, 27 SANYO
30, 31, 32 SHARP
35, 36 SONY
TOSHIBA
Code
70
29
to VCR.
to DVD.
DVD
VCR
.
Code
40, 41, 42, 43
45, 46
50
55, 56, 57, 58
60, 61
65, 66, 67
70, 71
~ . (The
0 9