Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
PARTS PROVIDED
Before attempting to assemble the CN piano unit, ensure that all parts are included. A Phillips-head screwdriver
will also be required to assemble the unit (not included).
(A) Piano (x 1)
(B) Pedal board (x 1)
(C) End panel (x 1 each for left and right)
(D) Back panel (x 1)
(E) Adjuster bolt (x 1)
(F) Screw:
(G) Screw:
(H) Screw:
(I) Screw: M6 x 25 (x 4)
(J) Cord clamp (x 2)
(K) Headphone hook and screws (x 1 set)
(L) Power cord (x 1)
ASSEMBLY SEQUENCE
1. Screw the adjuster bolt (E) into the threaded screw hole
provided on the pedal.
2. From the side of the screw that is already on the backside of
the pedal board (B), slide and insert the bracket of the end
panel (C).
3. While pressing the end panel (C) against the pedal board (B),
tighten the already-provided screws, one each on the left and
right sides, and then tighten two screws (F) on each side.
4. Untie and pull out the pedal cable.
5. Set the back panel (D) and tighten the screws (G) (H) into
the prepared holes. Loosely tighten the screws with the *
symbol.
Downloaded from
www.Manualslib.com
Ensure that this instruction manual is read thoroughly before attempting to assemble the CN
Caution
piano, and that two or more people work on assembly.
It may be necessary to tilt the unit by 90 degrees while assembling the CN piano. During this
time, ensure that hands are not caught in the piano, keyboard lid, or score stand, and that
the piano is not dropped on an individual's feet.
φ
4 x 16 (x 4)
φ
4 x 20 (x 4)
φ
4 x 30 (x 2)
Be careful not to scratch or damage the
Caution
fl oor, piano, or stand at the time of assembly.
manuals search engine
(E)
(F)
(G)
(H)
(I)
φ
φ
φ
Adjuster bolt
4 x 16
4 x20
4 x30
M6 x 25
1
(E)
2 3
Already-provided screw
4 5
(H)*
(Untie this twist tie from the cable)
(J)
(K)
Cord clamp
Headphone hook and screws
Screw
(x 2)
(F)
(F)
(C)
(B)
(D)
(H)*
(G)
(G)
(G)
Page
51
6
Advertisement
Table of Contents
