Tuning Your Vcr And Satellite Receiver; Tuning Your Tv To The Vcr - Panasonic TQBC0627-2 Operating Instructions Manual

Tuning your VCR and satellite receiver

Your new TV is supplied with programme position '0' set to receive an RF signal from your VCR, although a Scart
connection is preferable if the VCR is so equipped (see page 9, 10 or 45 for suitable inputs to the Scart socket on this
set.)
However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or sound
from your VCR on programme position '0' of this set. Either adjust the tuning of this TV programme position '0' (follow
the instructions below) or adjust the RF channel of your VCR (some VCR's allow adjustment of their RF channel via
their remote control unit) or both until this TV is tuned to the RF output channel of your VCR.
It is intended that this advice is used in conjunction with the instruction books for your additional equipment.

Tuning your TV to the VCR

Switch on the VCR, insert and play a pre-recorded tape with known content.
1
2
1 2 3
4 5 6
7 8 9
0
C
3
N
4
Notes:
• If picture patterning occurs on programme position '0' , or any others, it
may be necessary to adjust the RF output channel of the VCR, refer to the
VCR instruction book.
• If a Satellite Receiver and a VCR are going to be used with RF cable
connections it is important to avoid both units being set on the same
channel.
Refer to the Satellite Receiver and VCR instruction books for precise tuning
information.
• A VCR is used as an example. The above instructions also apply to other
equipments with RF output signal, e.g. DVD recorder, satellite receiver,
etc...
SET UP
Press to display the Setup menu
screen.
Press to select the Tuning menu.
Press to Access the Tuning menu
screen.
Press to select the Manual tuning.
Press to Access the Manual
tuning screen.
Press to select program position '0'
VCR.
Press to start seaching for the
VCR playback of the known
content tape.
When the VCR playback is found,
STR
press
TV/AV
Press to exit.
to store.
Setup menu
Q-Link
Off
AV2 out TV
Teletext
FASTEXT
Off timer
Off
Side panel
Off
Power save
Off
Tuning menu Access
Tuning menu
Programme edit
Auto setup
Manual tuning Access
Decoder (AV2)
Off
Shipping Condition
Owner ID
VCR
CH44
Programme
down / up
Serch
Return
down / up
TV/AV E x i t
'STR' Button Store
Manual tuning
21
VCR
The tape with known content
is found and displayed.
STR
Pressing will store the
setting.
68
35