Connect Wireless Devices To Your Powerline Access Point; Connect Wireless Devices Using Wps - TRENDnet TPL-410AP User Manual

TRENDnet User's Guide
Connect wireless devices to your powerline access point
A variety of wireless network devices can connect to your wireless network such as:

Gaming Consoles

Internet enabled TVs

Network media players

Smart Phones

Wireless Laptop computers

Wireless IP cameras
Each device may have its own software utility for searching and connecting to available
wireless networks, therefore, you must refer to the User's Manual/Guide of your
wireless client device to determine how to search and connect to this access point's
wireless network.
© Copyright 2016 TRENDnet. All Rights Reserved.
Connect wireless devices using WPS
WPS (Wi‐Fi Protected Setup) is a feature that makes it easy to connect devices to your
wireless network. If your wireless devices support WPS, you can use this feature to
easily add wireless devices to your network.
Note: You will not be able to use WPS if you set the SSID Broadcast setting to Disabled or
if you are using WEP or WPA security. Please note that WPS functionality will only be
available when using WPA2 security.
There are two methods the WPS feature can easily connect your wireless devices to
your network.
 Push Button Configuration (PBC) method
 (RECOMMENDED) Hardware Push Button method–with an external button
located physically on your access point and on your client device
 WPS Software/Virtual Push Button ‐ located in access point management page
 PIN (Personal Identification Number) Method ‐ located in access point management
page
Note: Refer to your wireless device documentation for details on the operation of
WPS.
Recommended Hardware Push Button (PBC) Method
 Note: It is recommended that a wireless key (passphrase or password) is created
before connecting clients using the PBC method. By default your access point is
preconfigured with a wireless encryption key. If no wireless key is defined when
connecting via PBC, the access point will automatically create an encryption key
that is 64 characters long. This 64 character key will then have to be used if one has
to connect computers to the access point using the traditional connection method.
To add a wireless device to your network, simply push the WPS button on the wireless
device you are connecting (consult client device User's Guide for length of time), then
push and hold the WPS button located on your access point for 3 seconds and release it.
The PWR LED will blink to indicate WPS has been activated on your access point.
TPL‐410AP / TPL‐410APK
9