Pc Input Terminals Connection - Panasonic TH-32LRT12U Operating Instructions Manual

Connections

PC Input Terminals connection

COMPUTER
Notes:
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 79.97 kHz and vertical
scanning frequency of 48 to 75 Hz. (However, the image will not be displayed properly if the signals exceed 1,200
lines.)
• The display resolution is a maximum of 1,024 × 768 dots when the aspect mode is set to "4:3", and 1,366 × 768 dots
when the aspect mode is set to "FULL". If the display resolution exceeds these maximums, it may not be possible to show
fine detail with sufficient clarity.
• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will need
to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
• Component Input is possible with the pin 1, 2, 3 of the Mini D-sub 15P Connector.
• Applicable input signals for Mini D-sub 15P (see page 29).
Signal Names for Mini D-sub 15P Connector
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Pin Layout for PC Input Terminal
12
Conversion adapter
(if necessary)
Connect a cable which matches
the audio output terminal on the computer.
Pin No. Signal Name
1 R (P /C )
R R
2 G (Y)
3 B (P /C )
B B
4 NC (not connected)
5 GND (Ground)
Mini D-sub 15p
RGB
PC cable
(Male)
Audio
Stereo plug
Pin No. Signal Name
6 GND (Ground)
7 GND (Ground)
GND (Ground)
8
9 +5 V DC
10 GND (Ground)
(Female)
Pin No. Signal Name
11 NC (not connected)
12 SDA
13 HD/SYNC
14 VD
15 SCL