Shark® 200T Quickstart Shark® 200T Quickstart Guide Mechanical Installation DIN Rail with black rubber stoppers Release Clip 200T DIN Installation Dimensions Installation Steps: Slide top of groove of meter onto DIN Rail. Press gently until the meter clicks into place. If mounting with DIN Rail provided, use Black Rubber Stoppers (also provided) shown above.
Page 2
200T meter’s RS485 port uses standard 2-wire, half duplex architecture. Factory Initial Default Settings: When the Shark 200T is powered up, for 10 seconds you can connect to the meter using the Factory Default Settings (even if the Device Profile has been changed). After 10 seconds the Device Profile reverts to the actual Device Profile in use.
Page 3
Set Pt-n value as 345, Pt-d value as 69, Pt-S value as 1000. Update Device: 8.When changes are complete, click the Update button to send a new profile to the Shark 200T meter. 9.Click Cancel to Exit the profile (or) click other tabs to update other screens.
Page 4
Shark® 200T Quickstart This page intentionally left blank. Electro Industries/GaugeTech Electro Industries/GaugeTech E149704 V.1.04 QS - 4 The Leader In Power Monitoring and Smart Grid Solutions The Leader In Power Monitoring and Smart Grid Solutions...