Lenovo ThinkCentre M700 User Manual page 94

8. Position the storage drive bracket on the system board so that the three slots on the storage drive
bracket align with the corresponding standoffs on the system board. Slide the storage drive bracket
as shown, until the screw hole in the storage drive bracket aligns with the corresponding mounting
stud on the system board, and the 2.5-inch storage drive is installed on the SATA 3.0 connector
on the system board.
Figure 53. Installing the storage drive bracket
9. Install the screw to secure the storage drive bracket to the system board.
Figure 54. Installing the storage drive bracket screw
10. If you have disconnected the front Wi-Fi antenna cable, reconnect it to the Wi-Fi card.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 90.
Replacing the M.2 storage drive
Note: The M.2 storage drive might come in two sizes, a smaller size as shown on the left side and a larger
size on the right side as shown in the figures in this section. Refer to the figure that matches your M.2
storage drive when reading this section. If your computer comes with the smaller M.2 storage drive, you will
not be able to replace it with a larger M.2 storage drive.
84
ThinkCentre M700, M900 and M900x User Guide