Cisco 7200 VXR User Manual page 39

Chapter 1 Cisco 7200 VXR Product Overview
Caution To prevent system errors and problems, use the CPU reset button only at the direction of your service
representative.
Table 1-22
lists LEDs on the NPE-G1.
LEDs are either on or off. The LED state (on or off), not the color, determines the status of connection.
Note
However, most LEDs are green when on, with the exception of the IO POWER OK LED, which is amber
when in the on state.
Table 1-22 I/O Controller LEDs
LED
ENABLED
IO POWER
OK
Slot 0
Slot 1
NPE-G1 LEDs
Table 1-23 NPE-G1 LEDs
LED Label
LINK, 0/1, 0/2,
0/3
EN (Enable),
0/1, 0/2, 0/3
SLOT ACTIVE CompactFlash
POWER ON
Input/Output Controller C7200-I/O LEDs
Figure 1-21
I/O controller has no port-specific LEDs.
78-5469-04 B0
lists LEDs common to all models of I/O controllers and describes their functions.
Color Function
Green Indicates that the network processing engine or network services engine
and the I/O controller are enabled for operation by the system; however, it
does not mean that the Fast Ethernet port on the I/O controller is functional
or enabled. This LED goes on during a successful router boot and remains
on during normal operation of the router.
Amber Indicates that the I/O controller is on and receiving DC power from the
router midplane. This LED comes on during a successful router boot and
remains on during normal operation of the router.
Green These LEDs indicate which PC Card slot is in use by coming on when
either slot is being accessed by the system. These LEDs remain off during
normal operation of the router.
LED Color
RJ-45 and Green
GBIC ports
RJ-45 ports Green
only
Green
Disk
Power Green
shows the LEDs on the I/O controller model with no Ethernet ports (C7200-I/O). This
LED status in the Power Up state
On, indicating that a link has been
established.
On, if the RJ-45 port is selected.
Off, if the GBIC port is selected.
On when the slot is being used.
On and stays on.
Table 1-22 describes the LEDs on this I/O controller.
Cisco 7200 VXR Installation and Configuration Guide
Field-Replaceable Units
Table 1-23
LED flashes when
there is traffic
No
—
—
No
1-39