Philips 32PFL3605/77 Service Manual page 19

Figure 5-10 Update the TV software 5
Figure 5-11 Update the TV software 6
Table 5-1 Error codes
1
Error Code x yy Event
0 00 no error
2 13 I
3 16 12V sensing of
platform supply
4 18 false POK-line display
or inverter
2 27 multi-standard
demodulator (IF)
2 34 tuner
Notes:
1. x = layer 1 error indication, yy = layer 2 error indication.
5.5 Fault Finding and Repair Tips
5.5.1 Speakers
Make sure that the volume is set to minimum during
disconnecting the speakers in the ON-state of the TV. The
audio amplifier can be damaged by disconnecting the speakers
during ON-state of the set!
5.5.2 Tuner
Attention: In case the tuner is replaced, always check the tuner
options.
Service Modes, Error Codes, and Fault Finding
18870_207_100209.eps
18870_208_100209.eps
in SDM
n.a.
2
C bus error layer 2
-
layer 2
layer 2
layer 2
Note:
• Do not remove the USB flash drive during the software
update.
• If a power failure occurs during the update, do not remove
the USB flash drive from the TV. The TV will continue the
software update as soon as power comes back.
• If an error occurs during the update retry the procedure or
contact your dealer.
• We do not recommend downgrading to an older version.
• Once the upgrade is finished, use your PC to remove the
TV software from your USB portable memory.
5.4 Error Codes
100209
The error code buffer contains all errors detected since the last
time the buffer was erased. The buffer is written from left to
right. When an error occurs that is not yet in the error code
buffer, it is displayed at the left side and all other errors shift one
position to the right.
100209
Error blinking
in CSM
n.a.
layer 1
-
layer 1
layer 1
layer 1
RAM1.0L LA
Defective board
spontaneous
n.a. n.a.
layer 1 SSB
layer 1 platform supply
layer 1 display supply/inverter
- SSB
- SSB
5. EN 19
2010-Jul-02