HP A3100-8 v2 SI Configuration Manual page 151

[ProviderA-Ethernet1/0/2] qinq enable
[ProviderA-Ethernet1/0/2] quit
Configure Ethernet 1/0/3
•
# Configure Ethernet 1/0/3 as a trunk port to permit frames of VLAN 10 and 50 to pass through.
[ProviderA] interface ethernet 1/0/3
[ProviderA-Ethernet1/0/3] port link-type trunk
[ProviderA-Ethernet1/0/3] port trunk permit vlan 10 50
# Set the TPID value in the outer tag to 0x8200.
[ProviderA-Ethernet1/0/3] quit
[ProviderA] qinq ethernet-type 8200
Configure Provider B.
2.
Configure Ethernet 1/0/1
•
# Configure VLAN 50 as the PVID of Ethernet 1/0/1.
<ProviderB> system-view
[ProviderB] interface ethernet 1/0/1
[ProviderB-Ethernet1/0/1] port access vlan 50
# Enable basic QinQ on Ethernet 1/0/1.
[ProviderB-Ethernet1/0/1] qinq enable
[ProviderB-Ethernet1/0/1] quit
• Configure Ethernet 1/0/2
# Configure Ethernet 1/0/2 as a hybrid port and configure VLAN 10 as the PVID of the port.
[ProviderB] interface ethernet 1/0/2
[ProviderB-Ethernet1/0/2] port link-type hybrid
[ProviderB-Ethernet1/0/2] port hybrid pvid vlan 10
[ProviderB-Ethernet1/0/2] port hybrid vlan 10 untagged
# Enable basic QinQ on Ethernet 1/0/2.
[ProviderB-Ethernet1/0/2] qinq enable
[ProviderB-Ethernet1/0/2] quit
• Configure Ethernet 1/0/3
# Configure Ethernet 1/0/3 as a trunk port to permit frames of VLAN 10 and 50 to pass through.
[ProviderB] interface ethernet 1/0/3
[ProviderA-Ethernet1/0/B] port link-type trunk
[ProviderA-Ethernet1/0/B] port trunk permit vlan 10 50
# Set the TPID value in the outer tag to 0x8200.
[ProviderB-Ethernet1/0/3] quit
[ProviderB] qinq ethernet-type 8200
Configure third-party switches.
3.
Configure the third-party switches between Provider A and Provider B as follows: configure the port
connecting Ethernet 1/0/3 of Provider A and that connecting Ethernet 1/0/3 of Provider B to allow
tagged frames of VLAN 10 and 50 to pass through.
144