TP-Link Archer VR600v User Manual page 103

Chapter 12
2 Visit http://tplinkmodem.net, and log in with the password
you set for the modem router.
3 Go to
Advanced >
current WAN Interface
4 Click
Add to add a new static routing entry. Finish the settings
according to the following explanations:
• Destination IP: The destination IP address that you want to
assign to a static route. This IP address cannot be on the same
subnet with the WAN IP or LAN IP of the router. In the example,
the IP address of the company network is the destination IP
address, so here enters 172.30.30.1.
• Subnet Mask: Determines the destination network with the
destination IP address. If the destination is a single IP address,
enter 255.255.255.255; otherwise, enter the subnet mask of
the corresponding network IP. In the example, the destination
network is a single IP, so here enters 255.255.255.255.
Specify Your Network Settings
Network > Advanced
and click Save.
Routing. Select your
98