PROCEDURE
Check to Make Sure
Auger Blade Stops Within
5 Seconds After Right
SAFETY
Control Lever is Released
Lubricate Control Levers
and Linkages
Check Snow Thrower for
Loose Hardware
Lubricate Hex Shaft and
Chains
Lubricate Auger Shaft
Fittings
Lubricate Chute Rotation
SNOW THROWER
Gear and Deflector
Mechanism
Remove All Snow and
Slush off Snow Thrower
to Prevent Freezing of
Auger or Controls
Check Tire Pressure
Oil, Check
Oil, Change
ENGINE
Check and Replace Spark
Plug
EMISSIONS CONTROL STATEMENT
Maintenance, replacement, or repair of the emissions control devices and
systems may be performed by any non-road engine repair establishment or
individual. However, to obtain "no charge" emissions control service, the
work must be performed by a factory authorized dealer.
SERVICE RECOMMENDATIONS
FIRST
BEFORE
AFTER
5
EACH
EACH
HOURS
USE
USE
✓
✓
✓
✓
✓
NOTE: The warranty on this snow thrower does not cover items
that have been subjected to operator abuse or negligence. To
receive full value from the warranty, operator must maintain
snow thrower as instructed in this manual.
The above Service Recom mendations are supplied to assist the
operator to properly maintain the snow thrower.
EVERY
EVERY
EVERY
5
10
25
HOURS
HOURS
HOURS
✓
✓
✓
✓
✓
✓
✓
MAINTENANCE
BEGINNING
BEFORE
EACH
STORAGE
SEASON
✓
✓
✓
✓
✓
✓
✓
✓
23