Table of Contents
Advertisement
Resetting the handset
You can reset individual settings and changes that you have made. Entries in the directory, the calls list and the handset's
registration to the base station will be retained.
¤ q
¤
§Menu§
Settings
Restoring the base station
When restoring factory settings:
◆
Individual settings are reset.
◆
All lists are deleted.
◆
The No Radiation mode is deactivated.
The date and time are retained.
Resetting the base station via the menu
When resetting via the menu
◆
Handsets are still registered.
◆
The system PIN is not reset.
¤ q
¤
§Menu§
Settings
Resetting the base station using the key on the base station
When resetting the base station using the key on the base station
◆
All handsets are de-registered and
◆
The system PIN is reset to the original code 0000.
Carry out the following steps: Remove the mains cable from the base station. Hold down the registration/paging key
¢
on the base station (
for at least 5 seconds.
Operating the base station on the PABX/router
Operating on the router
When operating the Gigaset on an analogue port of a router, you can reduce problems with echoing by activating the
¢
XES Mode (
page 16). If you have no problems with echoing, this function should be deactivated.
Operating on the PABX
The following settings are only necessary when your PABX requires them, see the user guide for your PABX.
When entering the digits, enter them slowly one after the other.
Changing the dialling mode
P#Q5#1N
¤
§Menu§
¤
1 = dial pulsing (DP)
enter number
Setting recall
P#Q5#1Q
¤
§Menu§
3 = 400 ms; 4 = 250 ms; 5 = 300 ms; 6 = 600 ms; 7 = 800 ms
Changing pause after line seizure
You can set the length of the pause inserted between pressing the talk key
P#Q5#1L
¤
§Menu§
¤
¤
.
§OK§
enter number
Changing the pause after the recall key
P#Q5#12
¤
§Menu§
¤
3 = 3200 ms
enter number
¤ q
¤
§§OK§§
§§OK§§
Handset
¤ q
¤ q
¤
§OK§
§OK§
Base
page 1) and reconnect the power cable to the base station at the same time. Hold the key down
¤
The number for the set dialling mode flashes: 0 = touch tone dialling (DTMF);
¤
.
§OK§
¤
The number for the current recall flashes: 0 = 80 ms; 1 = 100 ms; 2 = 120 ms;
¤
The number for the current pause length flashes: 1 = 1 sec.; 2 = 3 sec.; 3 = 7 sec.
¤
The number for the current pause length flashes: 1 = 800 ms; 2 = 1600 ms;
¤
.
§OK§
12
¤ q
¤
Reset Handset
¤
¤
§OK§
Base Reset
Reset?
¤
enter number
¤
¤
§§OK§§
§§OK§§
Reset?
¤
§OK§
¤
.
§OK§
c
and sending the phone number.
Advertisement
Table of Contents
