Russound X5 Quick Start Manual page 7

Booting
Solid yellow LED.
Access Point
Solid green LED and solid yellow LED.
Yellow LED may initially blink for a
short period of time.
Ready
Solid green LED.
Zone On
Solid blue LED.
Firmware Update
Blinking green LED
Reinitializing Access Point Mode
Depress the button on the bottom
panel for 2 seconds. Yellow and green
LEDs will blink 6 times then go solid.
If the Ethernet cable is connected,
the Red LED will blink as a warning
that the X5 will reboot in
wired-ethernet mode.
See page 5 "Connecting to a wireless network"
Factory-Init
Depress the button on the bottom
panel for more than 10 seconds.
The red LED will go solid while the
X5 is initialized to factory defaults.
The device will then enter Access Point mode.
IR Learning System On LED
IR Talkback System Status LEDs
Firmware Update During Initialization
Solid yellow, blinking green LED.
Network Error
Blinking yellow LED.
Access Point - Error
Solid green LED with yellow LED blinking
continuously. May require reinitializing
access point mode.
Error Codes
All LEDs can be used to display various
error codes. Error codes are derived from
the number of times each LED blinks.
X5 Bottom Panel
XStream X5 LED diagnostic chart
Yellow Green Red Blue
Reset Butoon
Note:
use non conductive tool
to depress the button
7