Connecting Cables - Siemens SINAUT ST7 System Manual

Introduction to the SINAUT ST7 system

1.8 Connecting cables

GPS receiver
Outdoor antennas
Type of antenna
Center frequency
Bandwidth
View angle
Power supply (over antenna cable)
Impedance
Power gain
Max. cable length without amplification
Plastic housing
Wind load
Degree of protection
Temperature range
•
•
Humidity
Lightning protection
Housing material
Dimensions (W x H x D) in mm
Weight
Grounding point
•
•
Current pulse withstand 8/20 µs wave
Response time
Protection level at 6 kV 1.5/50 µs wave at input
Insertion loss for DCF77 signal
Input / output
Input / output impedance
Degree of protection
Temperature range
•
•
Humidity
1.8 Connecting cables
A series of standard connecting cables is available to connect individual SINAUT
components with each other and to WANs. Some of these connecting cables are supplied
along with the hardware components. Other cables can be ordered as necessary.
56
Operation
Storage
Thickness of copper strand
length of copper strand
Operation
Storage
Micro-strip line with preamplifier
1575.42 MHz
10 MHz
+10° above horizon
4.5 to 7 V DC
50 ohms
20 dB
25 m
Light-resistant
max. 180 km/h
IP65
-30 °C through +80 °C
•
-40 °C through +85 °C
•
100%
Pressure die cast aluminum housing
250 x 105 x 95
Approx. 1.8 kg
M6 threaded connection
min. 10 mm2
•
max. 10 m
•
10 kA
< 1 ns
< 12 V
Max. 3 dB
BNC female / BNC female
50 ohms
IP40
-20 °C through +80 °C
•
-40 °C through +85 °C
•
95% no condensation
System Manual, 07/2009, C79000-G8976-C178-07
Station control system