A
12
1
2
3
4
Compression damping of fork
The compression damping is to be set at the lower end of the fork tubes. It
only regulates the degree of damping during compression.Remove closing
A
cap
. By using the knob
compression can be adjusted. Turn the knob clockwise to increase damping,
turn it counterclockwise to reduce damping during compression.
BASIC SETTING
– turn rotary knob clockwise as far as it will go
– turn it back counter-clockwise by as many clicks as are specified for the
relevant type of fork
WP 1418Y753 . . . . . . . .14 clicks
Rebound damping of fork
The rebound damping is to be set at the upper end of the fork tubes. It only
regulates the degree of damping during rebounding.
2
By using the knob
(REB), the degree of damping of the rebound can be
adjusted. Turn the knob clockwise to increase damping, turn it
counterclockwise to reduce damping during rebounding.
BASIC SETTING
– turn rotary knob clockwise as far as it will go
– turn it back counter-clockwise by as many clicks as are specified for the
relevant type of fork
WP 1418Y753 . . . . . . . .14 clicks
Compression damping of shock absorber
3
With the knob
the degree of damping of the compression can be
adjusted to 7 positions. Turn the knob counterclockwise to increase
damping, turn it clockwise to reduce damping during compression.
BASIC SETTING
WP 0118Y735 . . . . . . . .position 6
Rebound damping of shock absorber
4
With the setting wheel
the degree of damping of the rebound can be
adjusted to 11 positions. Turn the knob to the left side to increase damping,
turn it to the right side to reduce damping during rebounding.
BASIC SETTING:
WP 0118Y735 . . . . . . . .position 7
1
(COM), the degree of damping of the