Nesting Configuration Example; Network Requirements; Configuration Procedure - HP 5920 Configuration Manual

Nesting configuration example

Network requirements

As shown in
5 to transmit traffic. Because Site 1 and Site 2 are located in different areas, the two sites use the VPN
access service of a service provider. The service provider assigns VLAN 100 to the two sites.
Configure nesting, so that the two branches can communicate through the service provider network.
Figure 20 Network diagram
PE 1
XGE1/0/1
CE 1

Configuration procedure

Configuring PE 1
# Create a class named test to match traffic with CVLAN tag 5.
<PE1> system-view
[PE1] traffic classifier test
[PE1-classifier-test] if-match customer-vlan-id 5
[PE1-classifier-test] quit
# Configure an action of add outer VLAN tag 100 in the traffic behavior named test.
[PE1] traffic behavior test
[PE1-behavior-test] nest top-most vlan 100
[PE1-behavior-test] quit
# Create a QoS policy named test, and assocaite class test with behavior test in the QoS policy.
[PE1] qos policy test
[PE1-qospolicy-test] classifier test behavior test
[PE1-qospolicy-test] quit
# Configure the downlink port Ten-GigabitEthernet 1/0/1 as a hybrid port, and assign the port to VLAN
100 as an untagged member.
[PE1] interface ten-gigabitethernet 1/0/1
[PE1-Ten-GigabitEthernet1/0/1] port link-type hybrid
[PE1-Ten-GigabitEthernet1/0/1] port hybrid vlan 100 untagged
Figure 20, Site 1 and Site 2 in VPN A are two branches of a company, and they use VLAN
XGE1/0/2
VLAN 100 VLAN 5
VLAN 5 Data
VPN A
VLAN 5 Site 1
Public network
IP network
Data VLAN 100
VPN A
67
XGE1/0/2
XGE1/0/1
VLAN 5 Data
VLAN 5 Data
CE 2
Site 2
PE 2