Table of Contents
Advertisement
W
e
b
U
s
e
r
I
n
t
W
e
b
U
s
e
r
I
n
t
I
I
-
1
-
1
G
e
I
I
-
1
-
1
G
This section will introduce some general settings of Internet and explain the connection
modes for WAN1, WAN2 and WAN3/WAN4 in details.
This router supports multiple-WAN function. It allows users to access Internet and combine
the bandwidth of the multiple WANs to speed up the transmission through the network. Each
WAN port can connect to different ISPs, Even if the ISPs use different technology to provide
telecommunication service (such as DSL, Cable modem, etc.). If any connection problem
occurred on one of the ISP connections, all the traffic will be guided and switched to the
normal communication port for proper operation. Please configure WAN1, WAN2, WAN3 and
WAN4 settings.
This webpage allows you to set general setup for WAN1, WAN2, WAN3 and WAN4 respectively.
In default, WAN2 is disabled. If you want to enable it, simply click the WAN2 link and select
Yes in the field of Enable.
Available settings are explained as follows:
Item
Load Balance Mode
Index
Enable
54
e
r
f
a
c
e
e
r
f
a
c
e
n
e
r
a
l
S
e
t
u
p
e
n
e
r
a
l
S
e
t
u
p
Description
This option is available for multiple-WAN for getting enough
bandwidth for each WAN port. If you know the practical
bandwidth for your WAN interface, please choose the setting
of According to Line Speed. Otherwise, please choose Auto
Weight to let the router reach the best load balance.
IP Based - The same source / destination IP pair will select
the same WAN interface as policy. It is the default setting.
Sesseion Based- All of the WAN interfaces will be used (as
out-going WAN) for passing through new sessions to get
better transmission speed. Though good speed test result for
throughput might be reached; however, some web site may
not open smoothly, especially the site need authentication,
e.g., FTP.
If you have no strong demand about speed test result, keep
default settings as IP based.
Click the WAN interface link under Index to access into the
WAN configuration page.
V means such WAN interface is enabled and ready to be used.
Vigor2832 Series User's Guide
Advertisement
Table of Contents
