Table of Contents
Advertisement
User Manual
/
IBR350
APPENDIX
SAFETY, REGULATORY, AND WARRANTY GUIDE
CRADLEPOINT IBR350
CRADLEPOINT IBR350LPE
This important Product Information and Safety Guide contains safety, handling, disposal, regulatory, trademark, copyright, and software
licensing information. To avoid injury, read all safety information below and operating instructions before using the device.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Increase the separation between the equipment and receiver
•
Consult the dealer or an experienced radio/TV technician for help
FCC CAUTION
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20 cm between the radiator and your body.
To comply with FCC regulations limiting both maximum RF output power and human exposure to RF radiation, the maximum cellular
antenna gain must not exceed 3 dBi.
INDUSTRY CANADA STATEMENT
This device complies with RSS-210, RSS-102, and RSS-Gen of the Industry Canada Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
INDUSTRY CANADA RADIATION EXPOSURE STATEMENT
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20 cm between the radiator & your body.
This radio transmitters identified in the following table have been approved by Industry Canada to operate with the antenna types listed
below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included
in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
These devices have been designed to operate with cellular antennas having a maximum gain of 3 dBi. Antennas having a higher gain are
strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.
MODEL: S3A448A
MODEL: S3A506A
©2016 Cradlepoint. All Rights Reserved.
|
+1.855.813.3385
|
cradlepoint.com
5/6/16
69
Advertisement
Table of Contents
