Display Mode And Setting Change Message - Panasonic AJ-D700P Operating Instructions Manual

Display Mode and Setting Change Message

Messages informing of the contents of changed settings and adjustment results can be limited to
part of the displayed items or not displayed for all items.
The conditions under which messages are displayed and the corresponding display modes are
shown in the table below.
Setting change/adjustment results messages and display modes
Conditions under which
messages are displayed
When the filter selection is
changed.
When the gain setting is
changed.
When the WHITE BAL switch
setting is changed.
When the OUTPUT/AUTO
KNEE switch is set to AUTO
KNEE or OFF*)
When the shutter speed/mode
setting is changed.
When the white balance is
adjusted (AWB)
When the black balance is
adjusted (ABB)
*) The message is displayed for approximately 3 seconds immediately after the power for the unit is turned
on.
Message
ND: n (n=1, 2, 3, 4)
GAIN: n dB (n=–3, 0, 3, 6, 9, 12, 15, 18,
21, 24, 30)
WHITE: n (n=ACH, BCH, PRESET)
AUTO KNEE: ON (or OFF)
SS: 1/100 (or 1/120, 1/250, 1/500,
1/1000, 1/2000, S. SCAN, SUPER V)
Ex.) AWB: OK
See " Adjusting the White Balance"
(page 66) for a detailed description.
Ex.) ABB: OK
See " Adjusting the Black Balance"
(page 69) for a detailed description.
- 5 7 -
Display mode
setting
1 2 3
: Message displayed
: Message not displayed