Changing Input Types; Input/Output Mapping - Siemens i-3 User Manual

Chapter 4
Control Inputs/Outputs

Changing input types

All input types can be changed using
the Modbus communication protocol.
Refer to Modbus Map on page 14 for
more information.

Input/output mapping

Setting input/output mapping can
be accomplished using Modbus
communication protocol or the
configuration software.
Any given input to the I/O Board may be
connected to one output or to an output
group or zone (which is more than one
output). Refer to Modbus Map table in
Chapter 5 –Communication Protocols
under "Configuring i-3 V2 I/O Controller"
section for more information.
11