Bosch WFO 2860 Instruction Manual And Installation Instructions page 34

Cleaning water inlet
strainers
Cleaning the strainer(s)
at the water tap
Cleaning the strainer on the
washing machine
34
This is necessary if very little or no water flows into the
washing machine. The "Rinse"indicator light flashes
First release the water pressure in the supply hoses:
q Turn off the water taps.
q Turn the programme selector to any programme
(except "Spin" and "Drain").
q Press the "Start" button, and allow the programme
to run for approx. 40 seconds.
q Turn the programme selector to "Off".
On both the hot and cold water tap:
q Disconnect the hose from the water tap.
q Rinse the strainer under flowing water.
q Connect the hose.
On both the hot and cold water tap:
q Disconnect the hose from the back of the washing
machine.
q Pull out the strainer and rinse under running water.
q Insert the strainer and reconnect the hose.
q Turn on the water tap and check whether water is
still discharged. If water is still discharged, check
that the strainer is attached properly.
q Turn off the water tap.