Audiovox AS 9075 Installation Manual page 9

NOTE:
1) When selecting Diesel operation, (Feature Five), over gasoline, the only change is to the ignition 1 circuit.
When Diesel is selected, the ignition 1 circuit will power up 10 seconds before the start circuit. The intent of
this feature is to allow the glow plug warming required by some diesel engines. If your vehicle is a instant
start diesel, it is not necessary to activate this feature.
NOTE: When selecting Diesel mode, be certain that the intended vehicle has a true tach reference and be certain
to connect the tach input wire.
2) The difference between selecting Starter Pole 5X or Starter Pole 3X, (Feature Six), is considering the time it
takes from when the unit reaches the preset RPM to when the Starter Motor drops out. This feature allows
fine adjustments when you note a slight overcrank. If after programming tach, the unit seems to hold the
starter engaged slightly longer than necessary, select this feature to pole 3 X. If the unit starts and the starter
drops out properly, (NO OVERCRANK) no change is necessary.
To program these selectable features:
1. Start with the ignition switch in the "OFF" position and the programming switch in the "ON" position.
2. Turn the ignition key to the ON position.
3. Within 5 Seconds begin to toggle the control/program switch OFF - ON - OFF - ON - OFF then ON.
3a Parking Lights Turn On.
4. Within 5 Seconds, Turn the ignition key OFF, then ON.
4a Parking Lights Turn Off.
5. Within 5 Seconds begin to toggle the control/ program switch OFF - ON - OFF then ON.
5a Parking Lights Turn On For 3 Seconds Then Off Indicating Program Mode Entered.
6. Within 5 seconds of the lights turning off, begin to move the control/program switch off then on to sequentially
move through the programmable features.
Example: Move the switch on then off, the lights flash one time to indicate feature 1, run time is selected. Press and
release the brake to toggle between 10 or 15 minutes run time, or, move the switch on then off to advance to feature 2,
the lights will flash twice indicating feature 2, parking lights on or steady, is selected. Press and release the brake
to toggle between on or steady. Continue to move the switch on then off until you've moved through the programmable
features setting each with the brake pedal as described.
2. Programming Tach Rate:
NOTE: All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start
without first programming tach, the unit will flash the parking lights 7 times indicating tach has not been learned and
stored. If the tach rate is not properly programmed to the specific vehicle, the unit may not realize that the vehicle is
running, and in certain instances reengage the starter motor.
The AS 9075 Remote Car Starter will learn the tach rate of most vehicles single ignition coils, multiple coil packs,
and or single injector.
To learn tach;
1. Start with the ignition switch in the "OFF" position and the programming switch in the "ON" position.
2. Turn the ignition key to the ON position.
3. Flip the program switch OFF - ON - OFF - ON - OFF then ON.
4. Immediately turn the ignition key OFF.
5. Flip the program switch OFF, then start the vehicle using the ignition key.
6. When the unit senses the tach signal, the parking lights will begin to flash.
7. Flip the program switch ON. The parking lights will turn on for 3 seconds then turn off indicating that the tach signal
is stored and the tach program mode has been ended.
Diagnostics:
Enter selectable feature #4 and turn on as described in the programmable feature section.
NOTE: Diagnostic mode is a temporary mode. Once you have accessed the diagnostic mode, the unit will
pause for two seconds then begin to flash the last stored shut down code. This code will be displayed
three times in succession, then the unit will automatically exit the diagnostic on mode.
9