Frame Rec - JVC GY-HM600E Instructions Manual

5 Pause recording.
Press the [REC] button again to pause
0
recording. The display changes ("RRECC"
B "STBYC" (yellow text)).
The card slot status indicator remains lighted
0
in red.
6 Resume recording. (Recording 3)
Press the [REC] button again to resume
0
recording. The display changes ("STBYC"
(yellow text) B "RRECC").
The card slot status indicator remains lighted
0
in red.
7 Press and hold the [REC] button.
Recording stops and the display changes
0
("RRECC" B "STBYC"). A "clip" is
generated.
The card slot status indicator lights up in
0
green.
8 Press the [REC] button again.
The display changes ("STBYC" B
0
"RRECC") and the card slot status indicator
lights up in red.
A new "clip" is generated from here.
0
Memo :
The following operations cannot be performed
0
while recording is paused (STBYC, yellow text).
Clip Review operation
0
(A P70 [Viewing Recorded Videos Immediately
(Clip Review)] )
Switching SD card slots
0
Switching operation mode
0
(A P18 [Operation Modes] )
Files are split into sizes of 4 GB (or 30 minutes)
0
regardless of the menu settings.
Caution :
Do not remove the SD card during recording
0
(RRECC, red text) or recording pause
(STBYC, yellow text).
To remove the SD card in the "Clip Continuous"
0
mode, press the [CANCEL] button, check that
"STBYC" (white text) is displayed and the card
slot status indicator lights up in green before you
remove the card.
When the SD card becomes full during
0
recording, recording stops and "STOP" is
displayed.
When the [POWER ON/OFF(CHG)] switch is
0
turned off during recording or recording pause,
recording stops and power is cut off after a clip
is generated.
Caution :
If the power is cut off due to low battery power,
0
a proper clip may not be generated.
When [Format] in the [Main Menu] B
0
[System] B [Record Set] B [Record Format]
menu is set to "AVCHD", Clip Continuous Rec
cannot be performed.
(A P109 [ Format ] )

Frame Rec

In normal recording, when the recording stops, the
image and accompanying data from the start till the
end of the recording are recorded as one "clip" on
the SD card.
In this mode, recording starts with every press of
the [REC] button, and only the specified number of
frames is recorded.
The recording can be written to the media as a
single clip until it is stopped.
Memo :
Audio will not be recorded.
0
Until a specified amount of recordings is
0
accumulated, the file cannot be written to the
media.
If the specified amount is not reached when
0
recording is stopped, normal recording is
performed and frames are added to the ending
of the clip until the amount is reached. (Padding)
After the specified number of frames is recorded
0
and written to the media, recording will be
performed until the same number is
accumulated again.
Press [REC]
(Frame Rec starts)
Press [REC] Press [REC]
Recording resumes Recording resumes
Pause Pause
Records number of frames specified in [Rec Frames]
Actual clips recorded to the media
.
Specific amount of data
Press and hold [REC]
(Frame Rec stops)
Normal recording
Pause
(Padding data)
77