Changing Fcw And Active Braking Status - Dodge 2015 Charger SRT 392 Owner's Manual

To turn the FCW system back ON, push the forward
collision button again to turn the system ON (led turns off).
Changing the FCW status to "Off" prevents the system
from warning you of a possible collision with the vehicle
in front of you.
Changing the Active Braking status to "Off" prevents the
system from providing limited autonomous braking, or
additional brake support if the driver is not braking
adequately in the event of a potential frontal collision.
NOTE: The FCW system state is kept in memory from
one ignition cycle to the next. If the system is turned OFF,
it will remain off when the vehicle is restarted.

Changing FCW And Active Braking Status

The FCW Sensitivity And Active Braking Settings are
programmable through the Uconnect® System. Refer to
"Uconnect® Settings" in "Understanding Your Instru-
ment Panel" for further information.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 197
The default status of FCW is the "Far" setting and the
Active Braking is the "On" setting, this allows the system
to warn you of a possible collision with the vehicle in
front of you when you are farther away and it applies
limited braking. This gives you the most reaction time to
avoid a possible collision.
Changing the FCW status to the "Near" setting, allows
the system to warn you of a possible collision with the
vehicle in front of you when you are much closer. This
setting provides less reaction time than the "Far" setting,
which allows for a more dynamic driving experience.
NOTE:
• The system will retain the last setting selected by the
driver after ignition shut down.
• FCW may not react to irrelevant objects such as
overhead objects, ground reflections, objects not in the
3