Connections - Panasonic KX-TG1810NZ Operating Instructions Manual

Preparation
Displays
Display icons
Various icons appear on the handset display
to indicate the current status of the unit.
Display Meaning
icon
w
Within range of a base
unit
L When flashing:
L
Handset is accessing
base unit. (intercom,
paging, changing base
unit settings, etc.)
k
Handset is on an outside
call.
o
Call bar is on. (page 22)
5
Battery strength
Voice enhancer is set to
[VE]
high or low tone. (page
13)
Night mode is on. (page
[N]
20)
Key lock is on. (page 13)
[X]
Handset number: The left
[2]
icon shows handset 2
example. (page 21)
Base unit number: The
-2-
left icon shows base unit
2 example. (page 21)
0
New call minder
message received (call
minder users only; page
31)
Line is being used by
another handset.
8
Handset is searching
for base unit. (out of
range of base unit,
handset is not
registered to base unit,
no power on base unit)

Connections

When the AC adaptor is connected, a short
beep will be heard. If it is not heard, check
the connections.
Important:
L Use only the AC adaptor and telephone
line cord supplied with this unit.
Note:
L After connection, you must charge the
batteries to make or answer calls (page
9).
L Never install telephone wiring during a
lightning storm.
L The AC adaptor must remain connected
at all times. (It is normal for the adaptor to
feel warm during use.)
L The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight
of the adaptor may cause it to become
disconnected.
Hooks
(220–240 V, 50 Hz)
To telephone
network