Table of Contents
Advertisement
TG1805AL(e-e).book Page 37 Thursday, March 17, 2005 9:37 AM
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Initial settings
Problem
w is flashing.
The handset display is blank.
The handset will not turn on.
Cause & solution
L The handset is not registered to the base unit.
Register it (page 31).
L The handset is too far from the base unit. Move
closer.
L The AC adaptor is not connected. Check the
connections.
L The handset is not turned on. Turn the power on
(page 12).
L Make sure that the batteries are installed correctly
(page 11).
L Fully charge the batteries (page 11).
L Clean the charge contact and charge again (page
11).
Useful Information
37
Advertisement
Table of Contents
