Panasonic ER1511 Operating Instructions Manual page 4

About the LED display
After charging is
While charging
completed
HIGH
MID
LOW
glows.
blinks once
• "HIGH", "MID" or
every second.
"LOW" blinks.
While using
"HIGH" blinks ‑ The battery capacity is enough.
HIGH
"MID" blinks ‑ The battery capacity is approx.
MID
LOW
"LOW" blinks ‑ The battery capacity is approx.
• Charge the clipper when "LOW" starts to blink.
4
10 minutes after
charging is
completed
HIGH HIGH
MID MID
LOW LOW
blinks once
every  seconds.
• "HIGH/MID/LOW"
go out.
60% or less.
10% or less.

Charging without the charging stand
1. Slide the 0·CHARGE/1 switch to "0·CHARGE",
and insert the appliance plug into the clipper.
2. Plug in the adaptor into a household outlet.

AC operation
If you connect the AC adaptor to the clipper in the same way as for
charging, and turn on the power, you can use it even if the battery
capacity is low.
• If the clipper does not operate, charge the clipper for
approximately 1 minute.
• Be careful not to discharge the battery completely with the power
left turned on. It results in shortening the battery life.