Operating Procedures (With The System Controller) - Panasonic WV-CM1480 Operating Instructions Manual

OPERATING PROCEDURES (with the System Controller)

For the following procedure, the WV-CM2080, WV-CM1780 or WV-CM1480 needs to be set up first from the Setup menu.
The WV-CM2080, WV-CM1780 or WV-CM1480 can be controlled with the specified System Controller.
Given below is an example. For further details refer to the Operating Instructions supplied with the System Controller.
1. Select a Unit Address number by pressing the Numeric buttons, then press the UNIT button.
2. To select the input to be displayed, select a specified CAM NO. (input number assigned) by pressing the Numeric but-
tons, then press the CAM/SET button.
3. To open the Display Setting menu, press the SETUP/FUNCTION button for two seconds or more.
4. Move the cursor to the item parameter by moving the joystick up or down, then select the item parameter by moving the
joystick to the right or left.
5. Pressing the CAM/SET button will switch to the level indicator display, then pressing the MON/ESC button will return to
the menu display.
6. To close the menu, press the SETUP/FUNCTION button for two seconds or more
7. To activate the assigned function, select an assigned number by pressing the Numeric button, then press the SETUP/
FUNCTION button after pressing the SHIFT button.
Note: For function numbers refer to the Appendix on page 16.
14
MONITOR
OPERATE LOGIN ALARM UNIT
PROGRAM
SETUP CAM SETUP
SHIFT FUNCTION CAM FUNCTION
ALM RESET ALM SUSPEND AUTO
ALM RECALL B/W
VCR CAM MULTI SCREEN SELECT
DEF
AUX 2
STILL EL-ZOOM WIPER
– +
AUX 1
MON
SEQ PAUSE SEQUENCE PATROL PLAY
SLOW LOGOUT
ESC
PATROL PATROL
STOP LEARN
CAMERA BUSY PROHIBITED
System Controller
IRIS
CLOSE OPEN
IRIS RESET
UNIT A FOCUS
NEAR FAR
UNIT
AUTO FOCUS
L
UNIT B
ZOOM
WIDE TELE
CAM
HOME/PRESET
SET
PROGRAM
PRESET
360
WV-CU
UP
R
DOWN