Electrical Safety; Product Features - Black & Decker KC3610 Original Instructions Manual

ENGLISH
Only plug the Battery Charger in 230V
mains. Recharge the Battery only with the
provided charger. Before starting any work
on walls, floors or similar, make sure that all
power lines in the work area are switched
o at the main switchboard. Use a suitable
device such as a metal or electricity line
detecting device. If in doubt contact a
qualified electrician or your utility provider.
Both tools and work-pieces can heat up
considerably during the drilling operation.
Allow a su cient period of cooling before
handling. Wear appropriate gloves.
Safety Advice for Charger
Important! Danger! There are 3 pcs 1.2V
Ni-cd battery in screwdriver, Never
short-circuit the battery or expose it to
moisture. Do not store it together with any
metal parts which could short-circuit the
contacts. the machine could overheat, start
burning or explode.
Warning!
1. This appliance is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use
of the appliance by a person responsible
for their safety.
2. Do not recharge non-rechargeable
batteries
Vibration
The declared vibration emission values
stated in the technical data and the
declaration of conformity have been
measured in accordance with a standard
test method provided by EN 60745 and may
be used for comparing one tool with
another. The declared vibration emission
value may also be used in a preliminary
assessment of exposure.
Warning! The vibration emission value
during actual use of the power tool can
di er from the declared value depending on
the ways in which the tool is used. The
vibration level may increase above the level
stated.
When assessing vibration exposure to
determine safety measures required by
6
(Original instructions)
2002/44/EC to protect persons regularly
using power tools in employment, an
estimation of vibration exposure should
consider, the actual conditions of use and
the way the tool is used, including taking
account of all parts of the operating cycle
such as the times when the tool is switched
o and when it is running idle in addition to
the trigger time.
Labels on tool
The following pictograms are shown on the
tool; along with the date code
Warning! To reduce the risk of injury,
the user must read the instruction
manual.
The charger is intended for indoor
use only.
Read this entire manual carefully
before using the appliance.
Position of date barcode
The Date Code, which also includes the year
of manufacture, is printed into the housing.
Example:
2014 XX JN
Year of manufacturing

Electrical safety

Your charger is double insulated;
therefore no earth wire is required.
Always check that the mains voltage
corresponds to the voltage on the rating
plate. Never attempt to replace the charger
unit with a regular mains plug.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.

Product Features

1. Tool Holder
2. LED light
3. Switch
4. LED switch
5. Charging indicator
6. Charging hole