7
Clamp of quick-release
axle
84
Tightening sequence: 2x
each side, alternately
19 Nm
z
If fully tightened beforehand,
slacken right axle clamping
screws 1 again.
Removing the front-wheel
stand.
without centre stand
Remove the auxiliary stand.
Place the right brake calliper
and the left brake calliper onto
the brake disc.
Tighten screws 1 on left and
right to the specified tightening
torque.
Brake caliper on tele-
scopic fork
38 Nm
OE
Insert the ABS sensor into its
bore and install screw 1.
Remove the adhesive tape
from the wheel rim.
Operate the brake several
times until the brake pads are
bedded.
Firmly compress the front forks
several times.