Epson ET-2500 Start Here

ET-2500
Start Here
Read these instructions before using your product.
Note for Spanish speakers/Nota para hispanohablantes:
obtener instrucciones de configuración en español, consulte la Guía de
instalación en epson.com/support/et2500sp (requiere una conexión a
Internet).
1
Unpack
Note: Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective materials
from inside the product.
Caution: Do not touch the flat white cable or the ink tubes and
their translucent cover.
3
Lower the scanner unit.
Para
2
Fill ink tanks
Note: This product requires careful handling of ink. Wear disposable
gloves and place a sheet of paper under the ink tank unit when you
fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink gets on
your clothes or belongings, it may not come off.
Warning: Keep the ink bottles out of the reach of children and do not
drink the ink.
1
Open the ink tank unit cover, then remove the cap for the
cyan ink tank and attach it to its holder.
2
Unpack the cyan ink bottle.
3
Snap the bottle tip off, then remove the bottle cap.
Carefully remove the protective seal (avoid touching the ink
underneath the seal), then close the bottle cap tightly.
Caution:
4
Fill the tank using all of the ink in the bottle.
Note:
identify the color of each tank.
Caution:
Be sure to close the bottle cap tightly, or ink may leak.
Refer to the color coded sticker above the ink tank unit to
Be sure to fill each tank with the correct ink color.