Grill & Fan Blade Assembly; Operating Instructions - Dimplex DCPFQ35 Instruction Manual

GRILL & FAN BLADE ASSEMBLY
1. Unscrew the spinner clockwise (or take the spinner out from the bag) and the
plastic nut counterclockwise to remove both of them. Fix the rear grill to the
motor then tighten the plastic nut again. (Fig.4)
2. Insert the blade into shaft, and make sure the rotor shaft pin is fitted into
groove of the blade. Turn the spinner counterclockwise to tighten the blade.
(Fig.5)
3. Fix the front grill and the rear grill with circlip clip and then use the fasten clip
to tighten the fan grill. (Fig.6)

OPERATING INSTRUCTIONS

Plug in the power adapter, after a "beep" tone, the fan is on standby.
1. Remote Controller (Fig.7)
ON/OFF KEY
Press this button under standby mode, the fan starts at normal mode of level
10, then the panel displays "normal mode, level 10". Press this button during
working, the fan turns off to standby mode.
After start, rotate the drive plate clockwise, the fan increases from the current
level circulation in the following manner: ...... silent 01 g silent 09 g normal
mode 01 g ...... g normal mode 26 g natural breeze mode g sleep mode g
smart mode g silent 01 g......, rotate the drive plate counterclockwise, the fan
will decrease from the current level in the following manner: ...... smart mode g
sleep mode g natural mode g normal mode 26 g ...... g normal mode 01 g
silent 09 g silent 01 g smart mode g ......
6