IBM x3200 4362 User Manual page 40

4. Locate the DIMM connectors on the system board. Determine the connectors
5. Open the retaining clips and, if necessary, remove any existing DIMM.
6. Touch the static-protective package that contains the DIMM to any unpainted
7. Turn the DIMM so that the DIMM keys align correctly with the slot.
8. Insert the DIMM into the connector by aligning the edges of the DIMM with the
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 42.
26
System x3200 Types 4362 and 4363: User's Guide
into which you will install the DIMMs. Install the DIMMs in the sequence shown
in the following table.
Number of DIMMs
1
2 (interleaved configuration)
3
4 (interleaved configuration)
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
metal surface on the server. Then, remove the new DIMM from the package.
slots at the ends of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the DIMM
is firmly seated in the connector. If there is a gap between the DIMM and the
retaining clips, the DIMM has not been correctly installed. Open the retaining
clips, remove the DIMM, and then reinsert it.
Installation sequence (connectors)
1
1, 3
Not supported
1, 3, 2, 4