Before You Begin - Weslo Cadence 200 User Manual

TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet (see page 10). If an
extension cord is needed, use only a 3-conductor, 1mm
1.5 m (5 ft.). IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the circuit breaker located on the treadmill
near the power cord. If the switch protrudes as
shown, the circuit breaker has tripped. To reset the
circuit breaker, wait for five minutes and then press
the switch back in.
d. Check the on/off switch located on the frame near
the power cord. The switch must be in the "on"
position.
PROBLEM: The power turns off during use
SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If
the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. Make sure that the on/off switch is in the "on" position (see d. above).
e. If the treadmill still will not run, please see the front cover of this manual.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE
POWER CORD. Remove the screws from the hood.
Carefully remove the hood. Locate the Reed Switch
(76) and the Magnet (47) on the left side of the Pulley
(77). Turn the Pulley until the Magnet is aligned with
the Reed Switch. Make sure that the gap between
the Magnet and the Reed Switch is about 1/8". If
necessary, loosen the Screw (3), move the Reed
Switch slightly, and then retighten the Screw.
Reattach the hood, and run the treadmill for a few
minutes to check for a correct speed reading.
2 (14-gauge) cord that is no longer than
c
Tripped Reset
Tripped
Reset
d
On
Position
a
1/8"
3
76 47
Top View
16

BEFORE YOU BEGIN

Thank you for selecting the new WESLO
200 treadmill. The CADENCE 200 treadmill is
designed to help you reach your exercise goals in the
convenience and privacy of your home. And when
you're not exercising, the unique CADENCE 200 can
be folded up, requiring less than half the floor space of
other treadmills.
or your benefit, read this manual carefully before
using the treadmill. If you have questions after read-
Walking Belt
Foot Rails
BACK
77
Rear Roller
Adjustment Bolts
® CADENCE ing this manual, please see the front cover of this
manual. To help us assist you, please note the product
model number and serial number before contacting
us. The model number of the treadmill is
WETL14805.1. The serial number can be found on a
decal attached to the treadmill (see the front cover of
this manual for the location).
Before reading further, please familiarise yourself with
the parts that are labelled in the drawing below.
Accessory Tray
Key/Clip
Storage Latch
5
Console
Water Bottle Holder*
Handrail
FRONT
Circuit Breaker
On/Off Switch
RIGHT SIDE
Incline Pin
Incline Leg
*No water bottle is included