Adding A Point To A Route; Taking A Detour; Stopping The Route; Using Suggested Routes - Kenwood DNX893S Quick Start Manual

3
Select the map.
4
Select an option:
• To zoom in or out, select
• To rotate the map view, select
• To switch between North Up and 3-D
views, select .
• To add or remove map layers, select
.
• To view specific categories, select
• To center the map on your current
location, select
• To view shortcuts for map and
navigation features, select

Adding a Point to a Route

Before you can add a point, you must be
navigating a route.
1
From the map, select
2
Search for a location.
3
Select a location.
4
Select Go!.
5
Select Add to Active Route.

Taking a Detour

While navigating a route, you can use
detours to avoid obstacles ahead of you,
such as construction zones.
While navigating, select

Stopping the Route

From the map, select

Using Suggested Routes

Before you can use this feature, you must
save at least one location and enable the
travel history feature
Settings).
Using the myTrends
predicts your destination based on your
travel history, the day of the week, and the
time of day. After you have driven to a saved
location several times, the location may
appear in the navigation bar on the map,
along with the estimated time of travel, and
traffic information.
Select the navigation bar to view a
suggested route to the location.
Navigation
or .
.
.
> Where To?.
> Detour.
> Stop.
(Device and Privacy
feature, your device
™

About Exit Services

NOTE: You must be on a major highway or
road to view exit services.
While navigating a route, you can find
.
businesses and services near upcoming
exits. Services are listed by category.
.

Finding Exit Services

1
From the map, select
2
Use the arrows to select an upcoming
exit.
3
Select an exit service tab.
4
Select a point of interest.

Navigating to an Exit

1
From the map, select
> .
2
Select Go!.

Avoiding Road Features

1
Select Settings > Navigation >
Avoidances.
2
Select the road features to avoid on your
routes, and select Save.

About Custom Avoidances

Custom avoidances allow you to avoid
specific areas and sections of road. You can
enable and disable custom avoidances as
needed.

Avoiding an Area

1
Select Settings > Navigation > Custom
Avoidances.
2
If necessary, select Add Avoidance.
3
Select Add Avoid Area.
4
Select the upper-left corner of the area to
avoid, and select Next.
5
Select the lower-right corner of the area
to avoid, and select Next.
The selected area is shaded on the map.
6
Select Done.
Gas
Food
Lodging
Restrooms
> Exit Services.
> Exit Services
5