Handset Settings; Quick Access To Numbers And Functions - Gigaset S790 Manual

Changing the set destination
number
É
¢ ¢
v
Room Monitor
¤
Enter and save number as described in
"Activating the room monitor and enter-
ing the destination number"
¢
( page 58).
Cancel/deactivate room monitor
Press the end call key a to cancel the call
when the room monitor is activated.
In idle status, press the display key
deactivate room monitor mode.
Deactivating the room monitor
remotely
Prerequisites: The phone must support tone
dialling and the room monitor should be set
for an external destination number.
¤
Accept the call from the room monitor
and press keys 9 ;.
The room monitor function will deactivate
after the call ends. There are no further room
monitor calls. The other room monitor set-
tings on the handset (e.g., no ringtone) will
remain activated until you press the display
§OFF§
key on the handset.
To reactivate the room function with the
same phone number:
¤
Turn on the activation again and save
¢
§Save§
with ( page 58).

Handset settings

Your handset is preconfigured, but you can
change the settings to suit your individual
requirements.
Quick access to numbers and
functions
You can assign a number from the directory
to each of the digit keys Q and 2 to
O.
§OFF§
to
The left and right display keys have a default
function. You can change the assignment
¢
( page 60).
The number is then dialled or the function
started by simply pressing a key.
Assigning digit keys
Prerequisite: You have not yet assigned a
number to the digit key.
¤
Press and hold the digit key
or
Press the digit key briefly and press the
display key
The directory opens.
¤
Select an entry and press
The entry is saved to the corresponding digit
key.
If you delete or edit the entry in the direc-
tory at a later date, this will not affect the
assignment to the number key.
§QuickDial§
.
Please note
Handset settings
§OK§
.
59