Kenwood KDC-U40R Instruction Manual page 7

Item
PRESET TYPE NML *: Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ MW/ LW). ;
TYPE MIX: Memorizes one station for each preset button regardless of the selected band (FM1/ FM2/ FM3/
MW/ LW).
KEY BEEP BEEP ON */ BEEP OFF: Activates/deactivates the keypress tone.
RUSSIAN RUS ON: Folder name, file name, song title, artist name, album name are displayed in Russian (if applicable). ;
RUS OFF *: Cancels.
OFF WAIT Sets the duration when the unit will automatically turns off (while in standby mode) to save the battery.
OFF ––– : Cancels ; OFF 20M *: 20 minutes ; OFF 40M: 40 minutes ; OFF 60M: 60 minutes
AUX SET AUX ON *: Enables "AUX" in source selection. Sound of the connected external component is produce through
the car speakers. ; AUX OFF: Disables "AUX" in source selection.
CD READ CD READ1 *: Automatically distinguishes between audio file disc and music CD. ; CD READ2: Forces to play as
a music CD. No sound can be heard if an audio file disc is played.
SWPRE SWPRE R */ SWPRE SW: Selects whether rear speakers or a subwoofer are connected to the line out
terminals on the rear of the unit (through an external amplifier).
SPEAKER SP OFF */ SP 5/4/ SP 6 × 9/6/ SP OEM: Selects the speaker size for optimum performance.
F/W xx.xx <Y>/ N *: Starts upgrading the firmware. ; Y /<N>: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
Maintenance
Cleaning the unit: Wipe off the dirt on the panel with a dry silicon or soft cloth. Failure to
observe this precaution may result in damage to the monitor or unit.
Cleaning the connector: The unit may not function
properly if the connectors between the unit and faceplate
are dirty. Detach the faceplate and clean the connector
with a cotton swab gently, being careful not to damage
the connector.
Handling discs
Do not touch the recording surface of the disc.
Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
Do not use any accessories for the disc.
Clean from the center of the disc and move outward.
Clean the disc with a dry silicon or soft cloth. Do not use any solvents.
When removing discs from this unit, pull them out horizontally.
Remove the rims from the center hole and disc edge before inserting a disc.
Selectable setting (Preset: *)
Connector (on the reverse
side of the faceplate)
7