Panasonic CQ-R223W Operating Instructions Manual page 12

Installation
E
(Continued)
N
G
L
I
Cautions:
S
H
• We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
• When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and
11
fingers.
First complete the electrical connections, and
then check them for correctness.(a page 25)
The included Mounting Collar
q is designed specially for this
unit. Do not use it to attach any
other model.
Mounting spring (L)
y Power Connector
Mounting Springs (R)
Engage Mounting
Springs (C) in the both
Mounting
sides of the mounting
Hole
holes of Mounting Collar
q firmly.
Mounting Spring
22
CQ-R223W
Insert Mounting Collar q into the
1
dashboard, and bend the mounting
tabs out with a screwdriver.
The tabs to be bent vary depending on the car.
To securely install the unit, fully bend a
number of the tabs so that there is no rattling.
Example:
Tab
q Mounting
Collar
Mounting Holes
t Mounting Bolt
Establish the rear of the unit.
2
After fixing Mounting Bolt t connection and
Power Connector y, fix the rear of the unit to the
car body by either method (a) or (b) shown on the
previous page.
3
Insert Trim Plate i.
After installation reconnect the
4
negative (–) battery terminal.
To Remove the Unit
Switch off the power of the unit.
1 Remove the removable face plate.
Press [ ]. (release button). The
removable face plate will be released.
Release button
REMOTE
NR
TUNE
2 Remove the Trim Plate i with a screwdriver.
3 Insert the Dismounting Plates u along the
grooves on both sides of the main unit
until "click" is heard.
Pull out the unit while pushing the plates
further inside.
Insert the tab
end in the
outer groove.
"Click"
4
Remove the unit pulling with both hands.
Contact
Push
i Trim Plate
Screwdriver
Insert
u Dismounting Plate
Pull out
CQ-R223W
E
N
G
L
I
S
H
12
23