Sound Setting - Panasonic CQDF202 Operating Instructions Manual

Panasonic car stereo system specifications sheet
Table of Contents

Advertisement

Troubleshooting
E
N
G
L
I
S
Radio
H
9
Trouble
Station is too far, or signals are too weak.
Select other stations of higher signal level.
The motor antenna relay control lead is not connected correctly.
Much noise in FM stereo
If there is a motor antenna in the car, connect the motor antenna
and monaural broad-
relay control lead to the motor antenna lead that is installed in the
casts.
car correctly.
The radio antenna is not extended enough.
Extend fully the radio antenna.
Battery cable is not correctly connected.
Preset station is reset.
Connect the battery cable to the terminal that is always active.
CD
Trouble
Disc is upside down.
Place disc in the correct direction with the label side up.
≥ Disc is dirty.
≥ Disc has scratches.
Clean disc, referring to the section on "Notes on CD/CD Media (CD-
Disc is in the CD com-
R, CD-RW)".
partment but no sound is
made, or disc is ejected
automatically.
A disc that has data other than CD-DA type is loaded.
Discs that have CD-DA type data should be used.
The unit may not successfully play back a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive)
and a disc which are incompatible one another. Refer to instruc-
tions for the concerned devices for details.
≥ Disc is dirty.
≥ Disc has scratches.
Clean disc, referring to the section on "Notes on CD/CD Media (CD-
Sound skips, bad sound
R, CD-RW)".
quality. (e.g. caused by
noise)
The unit may not successfully play back a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive)
and a disc which are incompatible one another. Refer to instruc-
tions for the concerned devices for details.
18
CQ-DF202W
(Continued)
Cause/Step
Cause/Step
CD (Continued)
Trouble
Mounting angle is over 30o.
Adjust mounting angle to less than 30x.
Sound skips due to vi-
bration.
Instable mounting.
Mount the unit securely with the mounting parts, referring to the
section on installation.
≥ Disc is defective.
≥ Mechanical trouble.
Disc is not ejected.
Press [OPEN] to open the panel and press [<] (eject). If normal op-
eration is not restored, call the store where you purchased the unit
or the nearest service station to ask for repairs.
The first track of a mix mode disc was reproduced. (Mix mode is a for-
Time is counted but no
mat in which data except music is recorded on the first track and music
sound comes out.
data is recorded on other than the first track in a session.)
Play back music data recorded on other than the first track.

Sound Setting

Trouble
Left and right balance, or front and rear balance is off on one side.
No sound from left,
Adjust balance/fader setting as appropriate.
right,
front
or
rear
speakers.
Cables are not correctly connected.
Connect the cables correctly.
Left and right sounds
The right speaker wire is connected to the left speaker and the left
are reversed in stereo
speaker wire to the right speaker.
listening.
Connect the speaker wires to the correct ones.
E
N
G
L
I
S
H
10
Cause/Step
Cause/Step
19
CQ-DF202W

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cq-df202w

Table of Contents