Table of Contents
Advertisement
Section 2 - Installation
Follow the instructions below to install a hard drive, connect to the network and power on the ShareCenter™ 2Go.
Open the packaging of the ShareCenter™ 2Go and carefully remove and unwrap its contents. .
To install ShareCenter™ 2Go on your local network, refer to the steps below:
1. Connect the power adapter plug to the ShareCenter™
2Go power receptacle.
2. Connect the ShareCenter™ 2Go using an RJ-45
Connector on an Ethernet Cable to your Local Network.
This cable should connect the ShareCenter™ 2Go to
your local network via a router or switch, or directly
to a computer for configuration.
3. Plug in the power adapter to a power receptacle.
D-Link ShareCenter™ 2Go User Manual
Installation
Hardware Setup
Network Storage Mode
7
Advertisement
Table of Contents
