Tiller Board - Golden Technologies Buzzaround Lite Service Manual

TILLER BOARD

NOTE: Refer to the current parts diagram for the current part number.
To replace the tiller board:
1) Remove the key from the key switch.
2) Place the scooter in drive mode.
3) Remove the battery box.
4) Remove the top half of the console.
5) Remove the speed control knob.
6) Disconnect the main harness from the
tiller board. See figure 6.
7) Disconnect the paddle pot from the
tiller board. See figure 6.
8) Remove the tiller board from the top
half of the console.
9) Disconnect the battery meter from the
tiller board. See figure 6.
10) Disconnect the key switch from the
tiller board. See figure 6.
11) Connect the battery meter to the new
tiller board.
12) Connect the key switch to the new
tiller board.
13) Install the new tiller board onto the top
half of the console.
14) Connect the paddle pot to the new
tiller board.
15) Connect the main harness to the new
tiller board.
16) Reinstall the top half of the console.
17) Reinstall the speed control knob.
18) Reinstall the battery box.
19) Insert the key and test the scooter.
WWW.GOLDENTECH.COM
Figure 6. Tiller Console Assembly
info@goldentech.com PAGE - 20