BMW DWA 5.1 Rider's Manual page 14

anti-theft alarm. Instead, the indi-
3
cator LED lights up.
Alarm
12
z
The duration of the alarm is
26 seconds. After another
12 seconds, the alarm is active
again. A triggered alarm can
be interrupted at any time by
pressing the button 2 of the
remote control. This function
does not change the state of the
anti-theft alarm.
Pressing the button 2 again de-
activates the DWA.
During the alarm, an alarm tone
sounds and the turn indicators
flash. The type of alarm tone can
be programmed.
Reason for an alarm being
triggered
After the anti-theft alarm has
been deactivated, the anti-theft
alarm indicator LED signals the
reason for a possible triggering of
the alarm for one minute:
1x flashing: motion sensor
2x flashing: ignition switched
on with anti-theft alarm armed
3x flashing: disconnection of
anti-theft alarm from vehicle
battery
This display goes out after a
minute, or when the ignition is
switched on. If several alarms
have been triggered, all causes
are shown. To request the rea-
son for the last triggering of an
alarm at a later time, proceed as
described in the following sec-
tion.
Requesting reason for an
alarm being triggered
Deactivating anti-theft alarm
( 13).
Switch on ignition.
Switch ignition off and then on
again 3x within 4 seconds.
Indicator LED lights up; ac-
knowledgment tone sounds
once.
Switch off ignition within 15
seconds and watch indicator
LED on motorcycle.
Indicator LED flashes
Count LED signals until num-
ber of signals is equal to first
number of secret code.
Switch on ignition.
Indicator LED goes out.
Repeat previous steps for addi-
tional numbers of secret code.
A maximum of three incor-
rect entries are permitted,
then the anti-theft alarm is acti-
vated for another ten minutes.