Self-Diagnosis Function And Service Modes; Service Mode Table; Dvd Self Diagnostic Function-Error Code - Panasonic DVD-S35E Service Manual

8 Self-Diagnosis Function and Service Modes

8.1.

Service Mode Table 1

The service modes can be activated by pressing various button combination on the player and remote control unit.
Player buttons Remote control unit buttons
PAUSE
+
OPEN/CLOSE
PAUSE
SKIP/SEARCH<<
OPEN/CLOSE
8.2.

DVD Self Diagnostic Function-Error Code

Error Code
U11
H01
H02
H03
H04
H05
H06
H07
F103
F498
F499
F4FF
F500
F501
F502
F503
F505
F506
F600
0 Displaying the UHF display F_ _ _
5 Jitter check, tilt adjustment
*Display shows J_xxx_yyy_zz
"yyy" and "zz" shown to the right have nothing to do with the jitter
value. "yyy" is the error counter, while "zz" is the focusdrive
value.
Refer to section 10.4. for Optical Pickup Tilt Adjustment
Procedure.
6 Checking the region numbers and broadcast system
7 Checking the program version
9 Lighting Confirmation Function of Display Tube
DISPLAY Checking the laser drive current
PAUSE Writing the laser drive current value after replacing the optical
pickup (do not use for anything other than optical pickup
replacement)
Initializing the DVD player
(restoring factory preset settings)
Error Content
Focus error
Tray loading error
Spindle servo error
Traverse servo error
Tracking servo error
Seek error
Power error
Spindle motor drive
error
Illegal highlight Position Big possibility of disc specification violation during
No communication
between Front Micro
Computer and Main
Micro Computer after
power on
No response from Main
Micro Computer when
key code is sent from
Front Micro Computer to
Main Micro Computer
Force initialize failure
(time out)
DSC error
DSC not Ready
DSC Time out error
DSC communication
Failure
DSC Attention error
Invalid media
Access failure to
management
information caused by
demodulation error
Application
Additional error explanation
(Spindle servo, DSC SP motor, CLV servo error)
Cannot switch off the power because of the panel
and system computer communication error
highlight display
Main Micro Computer hangs up
DSC stops in the occurence of servo error (starup,
focus error, etc)
DSC-system computer communication
(Communication failure caused by idling of DSC)
Similar disposal as F500
Communication error (result
although communication command was sent)
Similar disposal as F500
Disc is flipped over, TOC
incompatible disc
Operation stopped because navigation data is not
accessible caused by the demodulation defect
15
DVD-S35E / DVD-S35EB / DVD-S35EG / DVD-S31EG
Note
Refer to section 8.2. Self-
Diagnosis Function (UHF
Display).
Refer to section 10.4.
Optical Pickup Tilt
Adjustment
Refer to section 9
Optical Pickup
Replacement Procedure.
Refer to section 8.4.
Initializing the DVD
player.
error
error occured
unreadable,