Setup
Insert the battery into the unit and charge it.
Set the mode dial to [OFF].
1
The unit runs on AC power (status indicator lit red) and
the battery cannot be charged when the mode dial is set
to any position other than [OFF].
Open the card/battery
2
door.
Open the door by sliding the card/
battery door lever to the "OPEN"
position.
3
Insert the battery.
Ensure that battery is oriented
correctly, and push it into the
compartment in the direction of the
[▲] until it snaps into place and it is
locked by the lever.
(To remove the battery, press the
lever in the direction of the [ ].)
Close the card/battery
4
door.
Close the card/battery door and
slide the card/battery door lever to
the "LOCK" position.
Connect the AC adaptor
5
(supplied).
Connect the AC cable to the AC
adaptor and then to an AC outlet.
To AC outlet
* Do not use the AC cable and AC adaptor of this unit with other devices. Also, do not use
the AC cables and AC adaptors of other devices with this unit.
20
VQT1R00
1
Charging
Lever
AC adaptor
AC cable
*
Small gap here.