Charging Time And Available Recording Time; How To Remove The Sensor Tag; The Grip Belt - Panasonic Palmcorder MultiCam PV-GS9 Operating Instructions Manual

• Since the Battery will not be charged when the DC
Cable is connected to the AC Adaptor, disconnect
it from the AC Adaptor.
• The [POWER] Lamp and [CHARGE] Lamp light
up, and charging starts.
• When the [CHARGE] Lamp goes off, charging is
completed.
• When the battery is completely discharged, the
[CHARGE] Lamp blinks at fi rst, but the battery is
charged normally. When the temperature of the
battery is too high or low, the [CHARGE] Lamp
blinks and the charging time becomes longer than
usual.
2 Attach the charged Battery to the Camcorder.
Disconnecting the Power Source
Set the [OFF/ON] Switch
sliding the [BATTERY RELEASE] Switch
remove the Battery downward or DC Cable.
• When attaching or removing Battery, set the [OFF/ON]
Switch to [OFF] and make sure the [POWER] Lamp
is not lit.
• For other notes concerning this item, see page 61.
Charging Time and Available
Recording Time
CGR-D08R
CGR-D14
Charging Time
A
Maximum Continuous Recording Time
B
• "1 h 30 min." indicates 1 hour and 30 minutes.
• Battery CGR-D08R (PV-GS9/PV-GS12/PV-GS14)
or CGR-D14 (PV-GS15) is supplied.
• The times shown in the table are approximate
times. The numbers indicate the recording time
when the Viewfi nder is used. The numbers in
parentheses indicate the recording time when the
LCD Monitor is used. In actual use, the available
recording time may be shorter.
16
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo
to [OFF], and while
44
,
48
44
48
A 1 h
B
2 h 10 min. (1 h 45 min.)
A 1 h 30 min.
B 3 h (2 h 25 min.)
Before Use
• The times shown in the table are for continuous
recording at a temperature of 68 °F (25 °C) and
humidity of 60 %. If the Battery is charged at a
higher or lower temperature, the charging time
may be longer.
• The available recording time becomes shorter
if you use both of Viewfi nder and LCD Monitor
simultaneously when rotating the LCD Monitor
forward to record yourself or setting [EVF
ON/AUTO] to [ON].

How to remove the Sensor tag

1 Detach the end of the Grip Belt.
2 Remove the Sensor tag. Then, replace the
Grip Belt.

The Grip Belt

To Use as a Grip Belt
Adjust the length of the Grip Belt to the size of your
hand.
1 Detach the end of the Grip Belt.
2 Adjust the length of the Grip Belt to the size
of your hand.
3 Reattach the Grip Belt.