Temperature; Spin Drying Speed; Delayed Start Time; No Spin Drying - Asko 600 Series Service Manual

PROGRAMS AND OPTIONS W640, W650 AND W660
Super rinse
Adds 4 extra rinses to the Heavy wash, Normal
wash and Fast wash programs. 2 rinses are added
to the other programs.

Temperature

The tolerance for temperature measurement is ±
1°C. The water temperature range is 0°C - 95°C
(70°F - 200°F). A temperature that is selected to
be greater than 85°C, (185°F) is indicated by the
selected temperature, but the water will only be
heated to a maximum of 85°C (185°F).
In case of a thermistor fault the heating element
is set to the AV position and a fault indication is
shown on the display.

Spin drying speed

The spin drying speed can be raised or lowered
by , in steps of 100 rpm, from 600 rpm
to 1600, 1500, or 1400 rpm depending on the
model.

Delayed start time

With the button the start can be delayed
from 1-12 hours. Each button press reduces or
increases the delay by one hour. On the thirteenth
button press the hours are reset to zero.
Delayed start time is started/stopped with
Display of remaining time
This is always on after a program has been selec-
ted, unless the digital numbers are being used to
present other information.
CHOICE OF FUNKTIONS
Program change after start
It is possible to make changes in the washing pro-
gram even after the program has started. To pre-
vent a change being made by mistake, the
button must first be held pressed in for 3 seconds
to activate the program change function. By then
using , and the desired settings can
Enter
be selected and confirmed. After the
activated by this long press, the changes and re-
turn to the main program must be made within
15 seconds. After a change has been made, the
new program is shown on the display.
A change can only be made however if that part
of the program you want to change has not yet
80
been run. It is also necessary for the change to be
acceptable to the program that is running.
The following settings can be changed:
Economy and Efficiency (E2)
Before cooling or, if the program does not inclu-
de cooling, before discharge of the main wash
water has begun.
Super rinse
Before the final rinse has begun.
Short spin drying
Before the final spin drying cycle has begun.

No spin drying

Before the first spin drying cycle.
Temperature
Before the heating cycle.
Spin drying speed
Before the final spin drying cycle has begun.
Rinse sensor (W660)
Before the first rinse has begun.
.
Start/Stop
Menu
has been
Menu