Table of Contents
Advertisement
x
Troubleshooting
If you find any problem while viewing your TV, please check the following
guide. If any problem persists, contact your Sony dealer.
Troubleshooting guide
Symptom
Snowy picture
• The connection is loose
• The antenna setup is
Noisy sound
• Channel presetting is
• Signal transmission is
Distorted picture
• Broadcast signals are
Noisy sound
• The power cord,
No picture
• The TV is not turned
No sound
• The volume level is too
Good picture
• The sound is muted.
• The TV audio setting
No sound
26
Additional Information
Possible cause
or the cable is
damaged.
inappropriate.
inappropriate or
incomplete.
low.
too strong.
antenna or VCR is not
connected.
on.
low.
may be set to "Auto
SAP".
Solutions
• Check the antenna cable and connection
on the TV, VCR and at the wall.
• Check the antenna setup.
Contact a Sony dealer for advice.
• Preset the channel again.
• Try using a booster.
• Turn off or disconnect the booster if it is in
use.
• Check the power cord, antenna and VCR
connections.
• Press
.
POWER
• Press ! (main power) on the TV to turn
off the TV for about five seconds, then
turn it on again.
• Press VOL + to increase the volume level.
• Press MUTING to cancel the muting.
• Press MTS/SAP until "Stereo" or "Mono"
appears on the screen.
Page
24
–
20
–
–
24
10
9
10
10
13
Advertisement
Table of Contents
