Table of Contents
Advertisement
DATE/TIME DISPLAY
DISPLAY
. The date/time is displayed a n d c a n b e r e c o r d e d
together with the colour bar signal by setting the
Colour Bar/Night Eye/Camera Selection Switch to the
BAR position.
. Menu, calender, date and camera identificaion are
not displayed on the screen
DISPLAY POSITION
Month
Year
12
10
94
12
:
30
Minute
ID
DATE/TIME SETTING PROCEDURE
1
Set the Colour Bar/Night Eye/Camera Selection Switch
(27) to the the BAR position to show the date and time
2 While pressing the Check Button (25), press the Auto
White/Auto Black Set Switch (6) to the AWC position
and then release the Check Button (25) in order to
shift to the time setting mode as shown in the figure
CAUTION:
Release the Check Button (25) after press-
ing the Auto White/Auto Black Set Switch (6) to
the AWC position. If the Check Button is kept
pressed, the camera will not be shifted to the time
setting mode
Check
3. After releasing the
Button (25), press the
Check Button once again within 10 seconds to cause
the 'Date' section to blink
CAUTION: If the Check Button (25) has not been
pressed within 10 seconds and no character is
blinking, the time setting mode will be reset to
normal dlsplay mode
4. To increase the 'Month', press the Recording Tlme
Reset Button (21)
5 . For fast i ncrement mode, keep pressing t h e
Recording Time Reset Button (21).
6. After setting the correct 'Month', press the Check
Button (25) to set the 'Day', The 'Day' characters start
to blink
- 74 -
7. Press the Recording Time Reset Button (21) to change
the 'Day'
8. After setting the correct 'Day', press the Check Button
(25).
9. For setting the 'Year' and 'Hour', follow the same pro-
cedure used for the 'Month' or 'Day'
10. For Setting the 'Minute', press the Check Button (25)
after setting the 'Hour'
11. Press the Recording Time Reset Button (21) to change
the 'Minute'
12. If it is desired to set the 'Second'' wait for the Time
tone from a radio, etc, (the 'Minute' section is blink-
ing). As soon as the tone at the Time is heard, press
the Check Button (25)
The clock starts running and the character 'TIME SET
END' will be displayed for 1 second and then the dis-
play mode will be changed to the normal display
mode.
Notes:
1
The date and time (clock) will be powered by the
back-up battery even if the camera is tumed off.
2 The back-up battery lasts approxlmately 10 years
3 The accuracy of displayed date and Time (clock)
is approximately +60 seconds per month
ID SETTING
The setting of 0-9 and blank at the ID position is avali-
able
By each pressing down of the Auto Black/Auto White Set
Switch (6) toward the ABC position when in the data/time
Setting mode, the ID setting is advanced.
CAMERA STATUS DISPLAY
The camera status can be recorded together wih the
colour bar signal and the Date/Time character by keeping
the Check Button (25) pressed while the Colour Bar/Night
Eye/Camera Selection Switch (27) is set to the BAR posi-
tion
- 75 -
Advertisement
Table of Contents
